INSTALLATION STEPS IN DETAIL
Check the accessories according to the packing list before installation. After sorting each accessory separately, it will be simple to assemble. Except that the suction pipe need to be cut due to the height of the tank, other does not require auxiliary tools and easily completed by manual operation.

Step 1: Measure the Pipe Height
Equipped with cutting tools, due to the different heights of fish tanks, it is recommended to measure and cut the water suction pipe inside the tank. After all are installed, hang it on the outside of the fish tank wall, also be used for fish tanks with frames.

Step 2: Install Other Accessories
Both the outlet and inlet pipes are equipped with suction cups to strengthen their fixation on the wall of the fish tank. It is recommended to match a water pump(flow rate of 520GPH~800GPH or above) and hose.

Step 3: Water Filtration Circulation Route
The entire outlet pipe uses the siphon principle to move dirty water to the bottom container for filtration, and some impurities are deposited and discharged separately. The inlet pipe part absorbs clean water from the bottom container into the aquarium through a water pump.
Power outage and on, Automatic operation

Scenario 1
After the power outage, the water pump stops, and the upper inlet pipe stops adding water. (Dual outlet prevents water from flowing back and overflowing).

Scenario 2
The outlet pipe is still running, the water level keeps dropping until the siphon ball is exposed,air enters,the siphon stops,no longer sucks water out

Scenario 3
After the power is on, the pump starts, water flows into the upper water inlet pipe, the water level in the tank rises, and the water gradually submerges the siphon ball.

Scenario 4
After the water submerges the siphon ball, water automatically starts to flow in the outlet pipe, and the water flow changes from small to normal.
SWITCH VALVE INTRODUCTION

Middle Valve: Water Flow Control
The bottom edge of the tank should be aligned with the table. The middle valve is the outlet water flow control valve. According to the flow rate of the water inlet pipe, adjust this valve to avoid the water inlet being greater than the water outlet flow, causing the tank to overflow.

Both Sides Valves: Fish Waste Collector
- The collection intercepts most of the impurities.
- Settle in the sedimentation box
- It is discharged through the discharge valves on both sides
- (Before opening the valve, tie the top hose to prevent air from entering and affecting the operation. when discharged, dirty water in the outlet pipe drops sharply)
Product Advantages

A surface skimmer, run by the water flow ,effectively absorbs the oil film on the water surface.

The high-quality 304 stainless steel filter net can intercept most fish impurities.

In landscaping tanks, the outlet pipe not be close to or buried in sand, gravel, etc.Maintain a height distance of at least 2in to avoid clogging pipe.

Usage Tips

The two separate parts can be installed according to the situation of the fish tank. The inlet and outlet pipes are placed on one side or on both sides.

The bottom container is with 4 pipes(5 feet), suitable for extra-long fish tanks. The remaining part can also be used for cutting in other locations.

First use, use the equipped hopper to add water into the water outlet pipe, then start the water pump to avoid air in the pipe and inability to operate.

The connections of the pipes can be sealed with Tape Geors(included) or glued (not included) as required. Used inside the connection of thin pipe.






Reviews
There are no reviews yet.